Asus X502C-RB01 Fan Replacement

Jika lubang angin komputer riba anda tersumbat dengan terlalu banyak habuk atau berputar terlalu kuat, anda mesti mahu membersihkan atau menggantikannya. Panduan ini akan menunjukkan kepada anda cara untuk mendapatkan kipas dan mengeluarkannya untuk membersihkan habuk.

Step 1  Keyboard Panel

• Turn off the laptop  and flip it face down.

• Using a phillips #0 screwdriver, remove the seven 9mm screw circled in red.

• With the sane screwdriver, remove the four 5mm screws circle in orange.

Step 2 

• Flip the laptop face up and open the lid.

• Use the plastic opening tool to pry around the entire edge of the keyboard panel to loosen the panel from the base.

Be careful not to lift the panel just yet, as it is still connected to the motherboard.

Step 3

• Partially lift the panel up, revealing the two cables connected to the motherboard.

Step 4

• Disconnect the first ZIF cable by lifting the tab using the spuger tool or your fingernail and gently pull the cable out.

• Disconnect the second ZIF cable by lifting the tab using your fingernail and gently pull the cable out. This one is more difficult to reach with the spudger.

Step 5

• Remove the keyboard panel completely and set it aside. The internal components of the laptop are now exposed.

Step 6

• Locate the hard drive in the area highlighted in red.

• This demonstration model does not have a mounting bracket around the hard drive.

Step 7

• Remove the four 5mm screws from the hard drive mounting bracket using the Phillips #0 screwdriver.

Step 8

• Slide the hard drive in the direction away from the connector and lift it up to remove it.

Step 9  Motherboard

• Unplug the battery from the laptop by lifting the connector up with the flat end of the spudger.

• Unplug the two ZIF cables by lifting the tab using the spudger tool or your fingernail then pulling the cable out gently.

Step 10

• Unplug the bundled cable by pulling it away from the connector with a bit of force.

• Unplug the display cable connector by lifting the tape and pulling it away from the connector.

• Unplug the two antenna cables connected to the network interface card by prying it off with the flat end of the spudger.

Step 11

• Remove the four 5.5mm screws using the Phillips #0 screwdriver.

Step 12

• Gently lift the motherboard out of the casing.

Step 13 Fan

• Flip the motherboard over so the fan is right side up.

Step 14

• Disconnect the fan from the motherboard by pulling the power cable connector.

Step 15

• Remove the two 5.5mm screws using a Phillips #0 head screwdriver.

Step 16

• Detach the tape that connects the fan to the heatsink.

Step 17

• Lift the fan off to remove it from the motherboard.

Semoga tips ini dapat membantu anda. 

Jangan lupa share ya.

Anda ada masalah dengan MacBook/Laptop/Iphone?

Slow

Rosak

Serangan Virus

Jangan risau!! 

Kami boleh bantu menyelesaikan masalah anda.. 

Tak tahu dimana lokasi 

MACNOTE STUDIO UIA Gombak?

Anda boleh hubungi kami melalui:

          ·   WhatsApp Abang M

          ·   Facebook Macnote studio

          ·   Careline 013 531 6110

Lot 1 As-Souq At-Tullab ,Mahallah Ali Ibn Talib, 

International Islamic University Malaysia, 

Universiti Islam Antarabangsa, 

53100 Jalan Gombak, 

Wilayah Persekutuan Kuala Lumpur

Google Maps : Macnote Mobile

E-mail  : macbookstation@gmail.com

Waktu Operasi : Isnin - Ahad (10 a.m. - 9 p.m.) Setiap Hari

Anda boleh datang terus ke MACNOTE di UIA Gombak:

1. KAMI DI GOMBAK ( DALAM UIA GOMBAK)

- 15 MINIT DARI KEPONG DAN SELAYANG

- 25 MINIT DARI BANGSAR DAN AMPANG 

- 30 MINIT DARI SETAPAK DAN SENTUL

-40 MINIT DARI PUCHONG DAMANSARA DAN CHERAS